Keeping hands warm during winter
#1
Newbie
Thread Starter
Keeping hands warm during winter
Learned a good lesson today, I used surgical gloves underneath my gloves on a ride today, kept my hands pretty warm. Been thru about 20 different gloves and none worked for keeping the hands warm. The surgical gloves kept the moisture away from the gloves.
Hope this helps with winter riding.
Cheers! and Merry Christmas!
Hope this helps with winter riding.
Cheers! and Merry Christmas!
Likes For VoodooSix:
#2
Sr Member on Sr bikes
On yesterday’s ride (27°F/19° wind chill) I was thinking about adding surgical gloves. I use water resistant mittens made with wind stopper fabric. They work pretty well, but I can still feel just a bit of cold air coming through. Not quite as cold today, but I think I’ll give it a try when ride.
Dan
Dan
#3
Senior Member
Join Date: Jan 2020
Posts: 2,078
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 596 Post(s)
Liked 832 Times
in
485 Posts
my electric gloves work pretty well once it gets below 40 much about that then they are too warm even without power. I used them on my 30 minute ride that got down to 17 thats a bit low and a longer ride. would haven needed more maybe those hand warmers inside.
#4
Full Member
Join Date: Jun 2008
Location: SW Ohio
Posts: 379
Bikes: 2016 Masi strada vita due, 2019 Kona Dew Plus
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 256 Post(s)
Liked 74 Times
in
51 Posts
You have to be flexible- I took 4 pair gloves on todays ride- thin liners, heavy polypro liners, heavy gloves, waterproof shell. I mix combinations of gloves depending on conditions- 1st starting out/10+mile warmth, headwind/tailwind, uphill/downhill, morning cold/afternoon warmth.
#5
Junior Member
When I didn't have a car I used a pair of neoprene gloves and if it got really cold a pair of gore- tex over mitts over the neoprene. That worked well and that was for Wisconsin winters.
Now I only go out if its above freezing and with wool gloves with a leather over glove so they don't wear out.
Now I only go out if its above freezing and with wool gloves with a leather over glove so they don't wear out.
#6
Senior Member
My DIY heated liner gloves have made winter riding so much more enjoyable since I started using them regularly last January. This year I haven't even bothered putting my bar mitts on the bike. I've been tinkering with different versions for a few years, but it really came together last year when I switched to a USB-C power bank along with a USB-C 9V adapter and PWM module to power/control them.
My hands would always get cold later in a ride when my gloves got damp from sweat, and even with bar mitts they would get cold and numb.
My hands would always get cold later in a ride when my gloves got damp from sweat, and even with bar mitts they would get cold and numb.
#7
Senior Member
Join Date: Oct 2014
Location: Portland, OR
Posts: 11,825
Bikes: (2) ti TiCycles, 2007 w/ triple and 2011 fixed, 1979 Peter Mooney, ~1983 Trek 420 now fixed and ~1973 Raleigh Carlton Competition gravel grinder
Mentioned: 120 Post(s)
Tagged: 0 Thread(s)
Quoted: 4139 Post(s)
Liked 3,118 Times
in
2,024 Posts
My DIY heated liner gloves have made winter riding so much more enjoyable since I started using them regularly last January. This year I haven't even bothered putting my bar mitts on the bike. I've been tinkering with different versions for a few years, but it really came together last year when I switched to a USB-C power bank along with a USB-C 9V adapter and PWM module to power/control them.
My hands would always get cold later in a ride when my gloves got damp from sweat, and even with bar mitts they would get cold and numb.
My hands would always get cold later in a ride when my gloves got damp from sweat, and even with bar mitts they would get cold and numb.
Long ago I spent a week riding 12 miles to work, first several downhill, leaving the house at -5F (-20C). That was cold! I think I was using just my workhorse leather chopper mitts over wool mittens. I do remember very distinctly that I was quite glad the long hill showed up at mile 3 and I started warming before any frostbite. Once I had that fairing, the chopper mitts and liners always worked just fine. (Those things are a huge blessing in the wet too. I stopped using mine only because they compromise hand positions on the hoods and the really cold stuff rarely happens where I live now. But I did use it and fully appreciated it for my Seattle winters of commuting along the waterfront north-south for 17 miles each way. Dead into the storm winds and rain.)
Congrats on a good method of beating the system (the weather)!
#8
Senior Member
I've mostly been sticking to warmer than -15C unless its a shorter group ride that I drive to. I like to go out for 2-3 hours at a time, which is harder to do when it gets really cold.
I'd probably ride more in colder temperatures if I could keep my face warm without fogging my glasses. I had a thought that when wearing a winter jacket your face is always warmer with the hood up even when facing the wind. I'm not sure if that is due to back pressure created by the hood or just disrupting the air flow. It would be great if you could replicate that on a bike helmet. I'm not sure if you'd need to cover the helmet with a hood or just add a fringe that goes all the way around from strap to strap over the top. Not sure if it would be ridiculous or awesome to add a faux fir hood fringe over the top of a helmet for winter riding, though it would get in the way of my helmet light.
I'd probably ride more in colder temperatures if I could keep my face warm without fogging my glasses. I had a thought that when wearing a winter jacket your face is always warmer with the hood up even when facing the wind. I'm not sure if that is due to back pressure created by the hood or just disrupting the air flow. It would be great if you could replicate that on a bike helmet. I'm not sure if you'd need to cover the helmet with a hood or just add a fringe that goes all the way around from strap to strap over the top. Not sure if it would be ridiculous or awesome to add a faux fir hood fringe over the top of a helmet for winter riding, though it would get in the way of my helmet light.
#9
Senior Member
Join Date: Jul 2008
Location: 25 miles northwest of Boston
Posts: 28,969
Bikes: Bottecchia Sprint, GT Timberline 29r, Marin Muirwoods 29er, Trek FX Alpha 7.0
Mentioned: 109 Post(s)
Tagged: 0 Thread(s)
Quoted: 5040 Post(s)
Liked 3,248 Times
in
2,139 Posts
I've mostly been sticking to warmer than -15C unless its a shorter group ride that I drive to. I like to go out for 2-3 hours at a time, which is harder to do when it gets really cold.
I'd probably ride more in colder temperatures if I could keep my face warm without fogging my glasses. I had a thought that when wearing a winter jacket your face is always warmer with the hood up even when facing the wind. I'm not sure if that is due to back pressure created by the hood or just disrupting the air flow. It would be great if you could replicate that on a bike helmet. I'm not sure if you'd need to cover the helmet with a hood or just add a fringe that goes all the way around from strap to strap over the top. Not sure if it would be ridiculous or awesome to add a faux fir hood fringe over the top of a helmet for winter riding, though it would get in the way of my helmet light.
I'd probably ride more in colder temperatures if I could keep my face warm without fogging my glasses. I had a thought that when wearing a winter jacket your face is always warmer with the hood up even when facing the wind. I'm not sure if that is due to back pressure created by the hood or just disrupting the air flow. It would be great if you could replicate that on a bike helmet. I'm not sure if you'd need to cover the helmet with a hood or just add a fringe that goes all the way around from strap to strap over the top. Not sure if it would be ridiculous or awesome to add a faux fir hood fringe over the top of a helmet for winter riding, though it would get in the way of my helmet light.

#10
Senior Member
Join Date: Aug 2004
Location: Baltimore/DC
Posts: 2,919
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 164 Post(s)
Liked 149 Times
in
95 Posts
I used to commute every day through winter for 15 years. I found Dachstein Wool mittens under Gore-Tex over-mitts did the job. Lowest temps I rode in were -3F/-19C.
Shoes: leather Keens cycling shoe
I loved climbing hills during winter unfortunately I had a 3 mile downhill to start my commute.
I am retired but I still miss my commute.
Shoes: leather Keens cycling shoe
I loved climbing hills during winter unfortunately I had a 3 mile downhill to start my commute.
I am retired but I still miss my commute.
#11
Senior Member
Join Date: Aug 2004
Location: Baltimore/DC
Posts: 2,919
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 164 Post(s)
Liked 149 Times
in
95 Posts
I've mostly been sticking to warmer than -15C unless its a shorter group ride that I drive to. I like to go out for 2-3 hours at a time, which is harder to do when it gets really cold.
I'd probably ride more in colder temperatures if I could keep my face warm without fogging my glasses. I had a thought that when wearing a winter jacket your face is always warmer with the hood up even when facing the wind. I'm not sure if that is due to back pressure created by the hood or just disrupting the air flow. It would be great if you could replicate that on a bike helmet. I'm not sure if you'd need to cover the helmet with a hood or just add a fringe that goes all the way around from strap to strap over the top. Not sure if it would be ridiculous or awesome to add a faux fir hood fringe over the top of a helmet for winter riding, though it would get in the way of my helmet light.
I'd probably ride more in colder temperatures if I could keep my face warm without fogging my glasses. I had a thought that when wearing a winter jacket your face is always warmer with the hood up even when facing the wind. I'm not sure if that is due to back pressure created by the hood or just disrupting the air flow. It would be great if you could replicate that on a bike helmet. I'm not sure if you'd need to cover the helmet with a hood or just add a fringe that goes all the way around from strap to strap over the top. Not sure if it would be ridiculous or awesome to add a faux fir hood fringe over the top of a helmet for winter riding, though it would get in the way of my helmet light.
I liked neck gaiters, versatile and somewhat adjustable to do what one needs
Likes For balto charlie:
#12
Happy banana slug
Join Date: Sep 2015
Location: Arcata, California, U.S., North America, Earth, Saggitarius Arm, Milky Way
Posts: 3,365
Bikes: 1984 Araya MB 261, 1992 Specialized Rockhopper Sport, 1993 Hard Rock Ultra, 1994 Trek Multitrack 750, 1995 Trek Singletrack 930
Mentioned: 27 Post(s)
Tagged: 0 Thread(s)
Quoted: 1338 Post(s)
Liked 1,239 Times
in
745 Posts
I'm a weather weenie and don't ride much below 32F, and from 50 deg. down my hands would always be cold . I tried several kinds of gloves with no success, until someone mentioned downhill skiing gloves. I found a pair on clearance, and they're great! They're actually windproof, which is exactly what was missing from the others.
#13
QR-disc must die!!!
Join Date: Sep 2018
Location: Shenandoah Valley, Northern Virginia.
Posts: 703
Bikes: '99 Trek 520, '20 Kona Sutra (FOR SALE 48cm), '21 Simon-Bikes mini-velo and a chromoly-framed folding bicycle with drop-bars and V-brakes, that rolls even while folded.
Mentioned: 2 Post(s)
Tagged: 0 Thread(s)
Quoted: 396 Post(s)
Likes: 0
Liked 196 Times
in
144 Posts
I been relying on wool glomitts since I first discovered them, about 20 years ago.