Go Back  Bike Forums > Bike Forums > Winter Cycling
Reload this Page >

W106 Tires, not enough!

Notices
Winter Cycling Don't let snow and ice discourage you this winter. The key element to year-round cycling is proper attire! Check out this winter cycling forum to chat with other ice bike fanatics.

W106 Tires, not enough!

Old 01-17-07, 12:16 AM
  #1  
Senior_Member2
Thread Starter
 
diff_lock2's Avatar
 
Join Date: Apr 2006
Location: Finlando NOT: Orlando, Fl
Posts: 1,694

Bikes: Beater + Nishiki Bigfoot X-29

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
W106 Tires, not enough!

I have Nokian W106 studded tires front and back, the rear one is a bit bigger...

Im going down a pretty steep slop, and theres a mirror sheet if think ice (and its +3c - +5c).

And im turning (really slow), and a split second later im on the ground.

I fell down so smoothly that i just stayed on the ground cause i wasn't fully aware wtf happened.

I try to get up...uses less, no friction at all... so i slide over to the side of the road and get my feet in to some old snow and pull the bike over, and pretty much walk the bike around this ice patch.

I have pictures of the marks left in the ice, but i cant upload off my phone (vista) atm.

Just saying, there not totally ice proof...

Pics (Fixed)











Last edited by diff_lock2; 01-22-07 at 01:36 PM.
diff_lock2 is offline  
Old 01-17-07, 03:21 AM
  #2  
ex-everything.
 
soze's Avatar
 
Join Date: May 2006
Location: Charlestown, MA
Posts: 606

Bikes: venerable surly crosscheck

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 2 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
W106's aren't supposed to be used on sheet ice with much expectation of stability; they're for snow and hardpack and slush, anything that gives them a little something to bite into. Gotta go for the big meaty 200+ studded tires or the wood screw solution on sheet ice.
soze is offline  
Old 01-17-07, 06:03 AM
  #3  
Senior Member
 
Join Date: Jun 2005
Location: Iceland
Posts: 273
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Wet ice is the worst. I haven't tried the W106, but on my Nokian 240's I sometimes deflate them a little bit for more contact surface (less likely that no stud is reaching the ground).
__________________
My advice is free of charge and of respective quality.
1982 Miyata 912
1998 Wheeler 5900 with front and rear air cushion suspension
2015 Canyon Spectral 7.0 EX
j3ns is offline  
Old 01-17-07, 07:30 AM
  #4  
3 seconds
 
ColorChange's Avatar
 
Join Date: Sep 2006
Location: Chicago, NW burbs
Posts: 2,935
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by j3ns
Wet ice is the worst. I haven't tried the W106, but on my Nokian 240's I sometimes deflate them a little bit for more contact surface (less likely that no stud is reaching the ground).
+1

Make sure your inflation pressure is low if you think you'll be hitting ice, about 40 psi is pretty good. Also, be very careful turning! If you lean, you're probably going down. If you turn a little, slowly, you'll probably be OK on sheet ice.
ColorChange is offline  
Old 01-17-07, 07:41 AM
  #5  
Baby it's cold outside...
 
ViperZ's Avatar
 
Join Date: Jul 2005
Location: SK, Canada
Posts: 7,310

Bikes: Trek 5000, Rocky Mountain Wedge, GT Karakoram K2, Litespeed Tuscany

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Remember one of the biggest things is to stay off the front brake. Don't use it unless you absolutely have to. Once the front tire is locked up you lose all steering traction, or what little you may have to begin with.

Scan the road ahead, anticipate and be prepared beforehand..
__________________
-Trek 5000* -Project Litespeed* -The Italian Job* -Rocky Wedge* -The Canadian Connection*

Last edited by ViperZ; 01-17-07 at 08:30 AM.
ViperZ is offline  
Old 01-17-07, 08:04 AM
  #6  
Senior Member
 
Join Date: Nov 2002
Location: Regina, SK, CA
Posts: 945

Bikes: 2002 Rocky HT

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Can't say enough about the 296 Extremes, have yet to have a major crash on them in 3 years of winter riding. I have so much confidence in them that I will brake hard with the front on glare ice. It will only lock up for the last foot or so, which is easily controlable.
KrisA is offline  
Old 01-17-07, 08:50 AM
  #7  
Senior_Member2
Thread Starter
 
diff_lock2's Avatar
 
Join Date: Apr 2006
Location: Finlando NOT: Orlando, Fl
Posts: 1,694

Bikes: Beater + Nishiki Bigfoot X-29

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Im using around 60-65 PSI... Cause im 100-110kg atm. You think i should drop it down to 40 psi?

I will try that.

Also, yeah i know about braking and leaning... sometimes theres just so much you can do.
diff_lock2 is offline  
Old 01-17-07, 08:52 AM
  #8  
Senior Member
 
Join Date: Dec 2006
Location: White Bear Lake, MN
Posts: 60

Bikes: Klein Attitude(off-road), Cannondale M700(commuter), Nishiki Performance Equipe(Roadie)

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Sorry to hear about your fall first of all. The steep slopes can be tricky.

I spent a good week debating whether or not to go with the 106s or Mount and Grounds. I decided to buy a pair of M&Gs and have been very please with cornering performance on ice. Part of my decision against the W106s is the lack of stud placement to the outer edge and the narrow width, not to mention fewer studs than the M&Gs. I just felt the M&G was a better all-around tire. This not to say the 106 is a bad tire.

We had about 4 inches of snow here in the Twin Cities a couple days ago(about time), so today was a good test. The roads are now plowed well enough to have the shoulders back for safety. Today I ran the pressure at 20 psi/front and 25 psi/rear to deal with all sorts of slush, ice, hardpack, etc, etc. Tire pressure is definitely a key factor. I had no problems at all with my commute.

Before we had any snow, and since this is my first experience with studded tires, I "played" on glare ice lakes to get a good feel for their capabilities. The experience helped my handling skills immensely.
zipster is offline  
Old 01-17-07, 12:20 PM
  #9  
Baby it's cold outside...
 
ViperZ's Avatar
 
Join Date: Jul 2005
Location: SK, Canada
Posts: 7,310

Bikes: Trek 5000, Rocky Mountain Wedge, GT Karakoram K2, Litespeed Tuscany

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by KrisA
Can't say enough about the 296 Extremes, have yet to have a major crash on them in 3 years of winter riding. I have so much confidence in them that I will brake hard with the front on glare ice. It will only lock up for the last foot or so, which is easily controlable.
It's OK to do that if you have full studs, however even then, I primarily use the back brakes only, on deep rutted chop and ice... force of habit I suppose. You can survive and escape a lot of "Go Down" situations, if you stay off the front brake. If the front wheel isn't rolling, it's slipping or skidding, and that's what we generally want to avoid on ice.


As others have suggested, try lowering your tire pressures. Currently I'm using 30 psi front, 35-40 psi on the back of my 240 spike Continentals.
__________________
-Trek 5000* -Project Litespeed* -The Italian Job* -Rocky Wedge* -The Canadian Connection*

Last edited by ViperZ; 01-17-07 at 12:33 PM.
ViperZ is offline  
Old 01-17-07, 12:31 PM
  #10  
spinspinspinspin
 
fatbat's Avatar
 
Join Date: Nov 2004
Posts: 880
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by diff_lock2
Im using around 60-65 PSI... Cause im 100-110kg atm. You think i should drop it down to 40 psi?

I will try that.

Also, yeah i know about braking and leaning... sometimes theres just so much you can do.
40 psi would be much better- keeps the studs in contact with the ice more of the time.

The nokians have really beefy sidewalls, which helps prevent pinch flats. I've run mine down to ~15 psi in the front without problems, but i'm only 160lbs.
fatbat is offline  
Old 01-17-07, 09:42 PM
  #11  
Not an internet law-maker
 
Godwin's Avatar
 
Join Date: Dec 2006
Location: Calgary
Posts: 611
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
I'm really lazy, I haven't bothered changing my tires this year and finally winter hit us. Still using my serfas seca roads at about 100-110psi. I'm not finding it too bad though, a bit of spinning every once and a while but haven't fallen yet. We mostly get snow mixed with dirty slush with some refrozen slush.


Anyone have any good opinions on good 27" winter tires?
Godwin is offline  
Old 01-22-07, 01:36 PM
  #12  
Senior_Member2
Thread Starter
 
diff_lock2's Avatar
 
Join Date: Apr 2006
Location: Finlando NOT: Orlando, Fl
Posts: 1,694

Bikes: Beater + Nishiki Bigfoot X-29

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
finally can upload pics to the server.
This is were i fell











diff_lock2 is offline  
Old 01-22-07, 04:39 PM
  #13  
Senior Member
 
Join Date: Jun 2003
Posts: 18,138

Bikes: 2 many

Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 1266 Post(s)
Liked 323 Times in 169 Posts
To ride on what you show in the photos, you should have 296's with about 25 psi in the tires. You still don't bank the bike when you turn.

Depending on how you ride, your bike, and the ice conditions, you may be OK with 40 with 106's. If you can go lower without getting a pinch flat, experiment heading towards 25 psi. The lower the better.

I use 22 front and 25 rear with 296's on a heavy bike, with heavy panniers ocasionally, for ice like that with footprints. Don't hurry, pay attention the whole time. Learn how to control a fishtail while keeping the bike straight up and still pedaling. It takes practice, turn the bars in the direction the back slides.

A bike with suspension is very helpful on a surface like that.
2manybikes is offline  
Old 01-22-07, 04:44 PM
  #14  
Senior Member
 
Join Date: Jun 2003
Posts: 18,138

Bikes: 2 many

Mentioned: 13 Post(s)
Tagged: 0 Thread(s)
Quoted: 1266 Post(s)
Liked 323 Times in 169 Posts
Originally Posted by ViperZ
It's OK to do that if you have full studs, however even then, I primarily use the back brakes only, on deep rutted chop and ice... force of habit I suppose. You can survive and escape a lot of "Go Down" situations, if you stay off the front brake. If the front wheel isn't rolling, it's slipping or skidding, and that's what we generally want to avoid on ice.


As others have suggested, try lowering your tire pressures. Currently I'm using 30 psi front, 35-40 psi on the back of my 240 spike Continentals.
Try 20 front 25 psi rear. You will not slide as much. Not a huge difference but noticeable in all conditions. Especially the loose snow on the road that is really slippery.
2manybikes is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.