chainring removal
08-22-11, 03:21 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2011
Posts: 19
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
chainring removal
Hello, I'm trying to remove the outer and middle chainrings from the crank spider, and was trying to find out if there is something that would hold the rings in place instead of using a standard chainring nut tool. All suggestions welcome, Thanks.
08-22-11, 03:31 PM
#2
Senior Member
Join Date: Apr 2010
Location: Los Angeles, CA
Posts: 378
Bikes: Trek 600 Series, Miyata 610, Palo Alto Touring, Schwinn Paramountain
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Did you strip it? Sometimes inside there is a smaller size hex insert to stop the rings from moving. Is it stuck? Some penetrating oil might help after a soak. I had to resort to drilling them out on one occasion. More info please.
08-22-11, 06:28 PM
#3
Senior Member
Join Date: Aug 2005
Location: Pittsburgh, PA
Posts: 33,656
Bikes: '96 Litespeed Catalyst, '05 Litespeed Firenze, '06 Litespeed Tuscany, '20 Surly Midnight Special, All are 3x10. It is hilly around here!
Mentioned: 39 Post(s)
Tagged: 0 Thread(s)
Quoted: 2026 Post(s)
Likes: 0
Liked 1,096 Times
in
742 Posts
The inside "nuts" usually have a slot across their flange and a wide bladed screwdriver can be used (or modified with a file) to fit across the slot and keep the nut from turning.
08-22-11, 07:00 PM
#4
Senior Member
Join Date: Jul 2009
Posts: 11,128
Bikes: 1986 Alan Record Carbonio, 1985 Vitus Plus Carbone 7, 1984 Peugeot PSV, 1972 Line Seeker, 1986(est.) Medici Aerodynamic (Project), 1985(est.) Peugeot PY10FC
Mentioned: 22 Post(s)
Tagged: 0 Thread(s)
Quoted: 150 Post(s)
Likes: 0
Liked 34 Times
in
27 Posts
Sometimes the chainring bolts sieze with corrosion that form in their threads if the bike ir ridden often in wet conditiond. Spray the bolts with a release penetrant like PB Blaster. Let them sit overnight so the stuff wroks its way into the threads and corrosion then try unscrewring them again using the slots at the back of the barrel nuts for more leverage. If they still won't release from each other after a couple of repeat applications of the penetrant, you might have to graduate to the careful application of a bit of heat from mybe a butane torch but be careful, as the aluminum chainrings and crank spider cannot take as much heat as steel can.
Chombi
Chombi
