Question about Powertap SL+ hub and bearings
#1
Senior Member
Thread Starter
Join Date: Jul 2008
Posts: 262
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Question about Powertap SL+ hub and bearings
Hi guys!
I was doing some bike maintenance and while i was swapping out the freehub body on my Powertap SL+, i spun the wheel, holding the axle between my fingers. When doing so i felt a bit of a scratchy spin (like you might feel with a minor bearing issue). It was spinning quite well, so I figured the "scratchiness" was just the power meter component. Does anyone know if this is the case? Or is it supposed to spin very clean, like any other rear hub, and i might have an issue????
Thanks!
I was doing some bike maintenance and while i was swapping out the freehub body on my Powertap SL+, i spun the wheel, holding the axle between my fingers. When doing so i felt a bit of a scratchy spin (like you might feel with a minor bearing issue). It was spinning quite well, so I figured the "scratchiness" was just the power meter component. Does anyone know if this is the case? Or is it supposed to spin very clean, like any other rear hub, and i might have an issue????
Thanks!
#2
Senior Member
Join Date: Dec 2006
Location: So Cal
Posts: 2,678
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I know of nothing in the hub regarding the power meter components that would cause that so my guess is a bearing issue it should spin like any other hub.
__________________
It may not be fancy but it gets me were I need to go.
https://www.jtgraphics.net/cyclist_bicycles.htm
It may not be fancy but it gets me were I need to go.
https://www.jtgraphics.net/cyclist_bicycles.htm
Thread
Thread Starter
Forum
Replies
Last Post
Radish_legs
"The 33"-Road Bike Racing
12
07-17-17 10:44 PM