DIY Motion Analysis System
10-19-10, 07:24 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2009
Location: San Diego, CA
Posts: 2,606
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
DIY Motion Analysis System
Just wanted to share my weekend project with the board. I finally got a motion analysis system setup to work on my positioning. It uses 1-4 camcorders, MaxTraq 2D, AviSynth video utility and Dashware. MaxTraq and Dashware have free trials.
Basically it will record videos on the trainer with stickers (markers), merge all the videos into one, overlay speed/cadence/power/HR data and track all data points with angles/distance/velocity/acceleration/etc.
I can post details later if you like but that would take work so I didn't this time. GL
Basically it will record videos on the trainer with stickers (markers), merge all the videos into one, overlay speed/cadence/power/HR data and track all data points with angles/distance/velocity/acceleration/etc.
I can post details later if you like but that would take work so I didn't this time. GL
10-19-10, 08:18 PM
#2
Senior Member
Join Date: May 2008
Location: SoCal
Posts: 1,246
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Please. I've done it with one camera to watch knee angles and tracking....and used mirrors to capture two views (front and side) at the same time
Thread
Thread Starter
Forum
Replies
Last Post
Morimorimori
Electronics, Lighting, & Gadgets
2
07-21-19 04:05 PM
