Just a couple questions...
10-04-08, 09:16 PM
#1
Newbie
Thread Starter
Join Date: Oct 2008
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Just a couple questions...
Just began my first fixie build up last week. It's an 80s Miyata frame (1024 I think). Ordered some Mavic CXP22's laced to Formula hubs earlier this week after reading about them on here. Anyways, the bottom bracket needs to be replaced and I was wondering if this bottom bracket: https://www.benscycle.net/index.php?m...roducts_id=656
would fit and also if it would fit these cranks: https://www.benscycle.net/index.php?m...roducts_id=528
or these: https://www.benscycle.net/index.php?m...oducts_id=3927
also if you guys had any suggestions on cranks/bottom brackets. Thanks a mill.
would fit and also if it would fit these cranks: https://www.benscycle.net/index.php?m...roducts_id=528
or these: https://www.benscycle.net/index.php?m...oducts_id=3927
also if you guys had any suggestions on cranks/bottom brackets. Thanks a mill.
10-04-08, 10:02 PM
#2
One skid from blown knees
Join Date: Jun 2008
Location: New York City
Posts: 910
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Search for info on the frame you have to see what type of threading is used on the BB shell. Or, you can remove the current BB & get the info off of it.
10-04-08, 10:32 PM
#3
Newbie
Thread Starter
Join Date: Oct 2008
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
I did a little bit of research and I guess all of those Asian manufactured bikes are the English ISO threading so that should work. Thanks!
