Dahon frame bolt issue
#1
Newbie
Thread Starter
Join Date: Apr 2012
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Dahon frame bolt issue
Hi there, i have an Dahon Mu p8 foldingbike. The aluminium bolt is loose. The best position to fasten the frame is 20 mm before the frame! due to wear of the alu bolt.
Behind this point the frame is letting loose again.
Note: it is not the adjustment of the v-grip that causes the problem.
Has anyone had the same problem, hence an solution?
Behind this point the frame is letting loose again.
Note: it is not the adjustment of the v-grip that causes the problem.
Has anyone had the same problem, hence an solution?
#2
Senior Member
Join Date: May 2004
Location: Pacific Northwest
Posts: 3,095
Bikes: Too many....................
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Quoted: 11 Post(s)
Likes: 0
Liked 11 Times
in
6 Posts
Do you have a photo of the bolt in question? Thor has a vise grip repair kit, I would contact him and see if this is the solution. https://www.thorusa.com/accessories/special.htm
__________________
Speed Uno
Dawes Kingpin 2speed
Speed Uno
Dawes Kingpin 2speed
#3
Newbie
Thread Starter
Join Date: Apr 2012
Posts: 3
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times
in
0 Posts
Hi again, i have no photo but its the The V-Clamp Hinge version A or B (can't see the difference) shown here https://www.dahon.com/sites/default/f...ions_en_11.pdf on top of page 19.
I found the Vice Grip Repair Kit, but its completely unclear what it is, only the price is shown. Can anybody tell?
It is the alu clamp a mean which is loose.
I found the Vice Grip Repair Kit, but its completely unclear what it is, only the price is shown. Can anybody tell?
It is the alu clamp a mean which is loose.
#5
Senior Member
Join Date: Dec 2008
Posts: 1,821
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
Likes: 0
Liked 1 Time
in
1 Post