View Single Post
Old 02-08-10 | 08:45 AM
  #70  
robtown's Avatar
robtown
Muscle bike design spec
 
Joined: Oct 2004
Posts: 3,688
Likes: 3
From: Sterling VA

Bikes: 70 Atala Record Proffesional, 00 Lemond, 08 Kestrel Evoke, 96 Colnago Master Olympic, 01 Colnago Ovalmaster, 76 Raleigh Gran Sport, 03 Fuji World, 86 Paramount, 90 Miyata CF, 09 Ritchey Breakaway CX, Bianchi Trofeo, 12 OutRiderUSA HyperLite

Originally Posted by cccorlew
This is exactly my experience, right down to the Dettos and nails, including a "whoops, didn't loosen the straps enough"
I remember getting 1st generation Mavic (look type pedals) and being in love! The only thing better was when they came out with the floating cleat.
I had the same experience with a modern setup, a slotted cleat fastened with a two bolt pattern on newer shoes. My shoes strap tight with the slot over the pedal edge. I was riding slowly up a modest incline and slammed the front DT shifter to the small ring. It went too far and the chain fell off. I found that at slow speeds with my crank spinning free I couldn't balance enough to reach the straps. I slowed to a stop and did the Laugh-In slow drop to the non-drive side. It was at an intersection in front of a young(er) lady in an SUV.
I had a similar chain failure on a much steeper hill with SPD. At the last millisecond I got my left foot clear and stopped the fall.
__________________
Korval is Ships
See my Hyperlite 411 it's the photo model on OutRiderUSA web page
robtown is offline  
Reply