Originally Posted by
simonaway427
You should be able to:
1) Loosen the rear bolt with an allen key
2) Turn the knurled knob at the front to raise or lower the nose of the seat
3) Tighten down the rear bolt to fine tune the levelling - but make sure its tight ENOUGH to prevent fore and aft sliding of the seat.
If you've already reefed on the knurled knob with pliers without loosing the rear, and now its spinning freely from the bolt, you need a new front bolt/knob assembly - you've stripped it.
I think I already tried this and the front wouldnt move. Ill give it another shot. Worst comes to worst I will grab a new front bolt and throw it in. Not the first time, nor will it be the last time I destroyed something and have to replace a bolt(or 3 or 4).