Ppl been asking for pictures and though I didn't had much time to work on it latelly, here it goes:

Full shot of the bike



Detail on my broken shifter support. The problem was that the hole for the screw to enter wasn't deep enough so as I screwed it in harder, it was pushing the hole thing out.



Detail on my improvised dropouts. They worked out fine.



The "cable guide" under the BB. When I apply the GelCoat I will dig it deeper.



And that's why I regret integrating the BB in the frame, I ended up using a kinda narrow one.



The seat part. I'm proud of the brake fit, its working great.



Front section. Maybe my top tube has too thin walls (I used ~2mm), I don't trust sitting on it but it sure looks beautiful.



It will look great after I apply GelCoat to the lugs and varnish the bamboo.