That's easier said than done. I gave it a little try and I need to shave down about 1.5 mm around both of the fork's bosses. That would seriously suck. Even with my Dremel tool that would be a rather kludgy and possibly damaging solution to what should be a non-issue. It's a carbon fork and I'd rather just replace the bosses...but after quite a bit of internet searching I haven't found any info on whether those bosses can be removed and replaced...not even from Ritchey's manual for that part. They look like they come out, but as far as I know they are incorporated into the molding. Anybody know for sure?