Thread: BSC vs. ISO cogs?
View Single Post
Old 04-11-11 | 12:02 AM
  #3  
bleedingapple's Avatar
bleedingapple
Senior Member
 
Joined: Jan 2010
Posts: 698
Likes: 0
From: Portland, OR

Bikes: Leader 722TS, Surly Cross Check, GT Outpost, Haro Z16, Trek 1000

the guys in the other post was talking about the cog trimming a little bit of the peaks of the hub threads and narrowing the profile a little. I just cant remember if it was the DA cog being BSC that did that. Unless the DA is ISO too.
bleedingapple is offline  
Reply
0