Originally Posted by
TonyA
Yes, I've always noticed that the wheels don't spin quite so freely when installed, and wondered if I should make the adjustment looser to compensate. But it sounds like I've been doing them just right. That explains why my wheel hubs don't seem to wear nearly as much as my BB. Thanks again!
Sounds like your wheel bearings might be a bit tight if they don't spin as well after installation. You should be able to feel a little play in the axle when off the bike, then the QR tightening will remove that play. Too much play, and you'll still have a loose axle. Not enough play and the bearings will be tight.