SO hey guys, I measured the diameter of the dropouts and the axle of the front wheel and I am having a delta of 0.45 mm(.0177inch)
and for the rear wheel and dropout it's the same 0.45mm to remove for a proper fitting
The rearwheel is mounted on a 119,50mm(measure's were took on the flat surface of thecounter nut that holds the axle) hub and my rear spacing is 135mm
the front spacing for the fork is 100mm and the hub is 100.20
If the rear does fit with little spacing the alignment between the chain ring and hub wont be off?

Can you guide trough the process of fitting them is there any thread that shows bolt size spacers and etc?


Otherwise,
I think I am just goingn to return the wheel because of the hassle that I will have trying to fit the wheel and the fact that I wil have no choice but to go to my lbs so it could be done