Originally Posted by bobotech

I just re-read your posts and noticed you said it was a single wheel trailer. As far as I can tell, you would be best off mounting the hitch to the drop out area by the rear wheel on both sides.

I found this link at the indestructibles website: http://www.instructables.com/id/Sing...ching-to-Bike/ if you look at the page before it as well, it gives more detailed pictures.

You will need something like that. if you have to take it apart quickly, just get a couple of larger wingnuts to replace the standard nuts so you can easily spin them off when you get to your destination.

I noticed that the guy used a nylon locknut to hold the nuts in place by the pivot point. That way he could leave it a tad loose so that the trailer can pivot up and down. You probably won't find a larger wingnut with a nylon insert but what you could do is find a stepped collar of some sort. I found a picture of what I'm talking about: http://rickramsey.net/CRF230Flg/SeatBoltCollars.jpg You would then drill the hole on the trailer frame larger to fit around the smaller step on the collar. Then when you tighten down the wing nut, there should be enough clearance on the smaller step and the frame of your trailer to allow it to pivot even after the wing nut is tightened down firmly.