On a related note, my problem had been trying to remove the later Regina FWs with the splines instead of notches. Most QR axle end nuts are too big to let in the splined tool that you can get for Park. DD noted to me recently that there might be some removers available that will have thinner walls on it to let in the end nuts, but as it is the Park version of the remover has very thin walls already and it still does not go over most QR axle endd nuts. Will the only solution be to grind down the end nuts a bit to let in the tool, or can I buy smaller diameter end nuts to replace the ones I ahve on my hubs on the drive side rear wheels.
Chombi