Yeah once I threw on the seattube/bb shell onto it I noticed if I wanted to space and align the dropouts I'd need to raise it up some. So I'll cut out another spacer which will give me some more room. After looking at it I quickly noticed that I should of done the slot offset to utilize it completely. No biggie as it still works but not like it could with it offset.

I still have to stamp the spacing measurements on the acorn as the Water Jet couldn't handle cutting out smaller font through the 3/4" aluminum. Cutting out just this stuff took a little over two hours. Now it's time for drilling and tapping. Not to mention doing all the prints, routing sheet, etc.