Thanks to advice from this forum I took my vintage bottom bracket apart today, regreased it and reinstalled and was able to get rid of the annoying "click" it was making. I ordered the nashbar essential tool kit and it had everything I needed except an adjustable pin spanner wrench and the correct size lock nut wrench to take off the bb lock nut. Luckily the lock nut wasnt too tight and I wrapped a wrag and used a large pipe wrench to remove it without marring it up. then having some wood working skills I drill a 1/4 hole thru a piece of oak to fit over the axel then drill and grinded two nails into the board to make the wrench. Again luckily the cup wasn't on tight and came off easily.
Found the bearings essentially dry and a little rust on the sealed balls maybe because that plastic cup that was supposed to keep water off the axel wasn't in there. I didn't buy a new one to install because I'm thinking I'm gonna replace the older bearings with a modern sealed bearing if I can find the correct size. If anybody can recommmend one that will fit on the vintage 83' Raleigh SC I'd appreciate it. Anyway thanks for all the help. You really get a sense of accomplishment went you tackle a job like this. Also same day I replaced a broken spoke from the rear freewheel side but that was pretty easy. - Joe