Thread: Fork materials
View Single Post
Old 01-12-13 | 04:00 PM
  #24  
FBinNY
Senior Member
Titanium Club Membership
15 Anniversary
 
Joined: Apr 2009
Posts: 39,897
Likes: 3,865
From: New Rochelle, NY

Bikes: too many bikes from 1967 10s (5x2)Frejus to a Sumitomo Ti/Chorus aluminum 10s (10x2), plus one non-susp mtn bike I use as my commuter

Originally Posted by HillRider
OK, while you are at it get the data on stem and handlebar failures. These have the same consequences as a fork failure.

I once had the handlebar clamp bolt on a stem break and I was on the ground instantly. Fortunately it was at a walking pace as I had left a traffic light so my injuries were very minor but, at speed, it would have been far different.
There's a big difference between a handlebar, stem or top of steerer failure vs. a steerer/crown failure. The latter is an instant faceplant, as the front wheel falls away and the head goes to ground. The first may cause a crash, but not of the same kind and the consequences tend to be far less critical.
__________________
FB
Chain-L site

An ounce of diagnosis is worth a pound of cure.

Just because I'm tired of arguing, doesn't mean you're right.

“One accurate measurement is worth a thousand expert opinions” - Adm Grace Murray Hopper - USN

WARNING, I'm from New York. Thin skinned people should maintain safe distance.

Last edited by FBinNY; 01-12-13 at 04:49 PM.
FBinNY is offline