Originally Posted by
mrrabbit
If the current freehub is a 7-speed setup, you'll have to change the freehub - if available - and swap in a 8/9/10 freehub along with a slight spacer/locknut change on the drive side as well. Splined 7-speed freehub bodies and narrower than splined 8/9/10 freehub bodies and both are complemented with differing size axle-end finishing lengths. Non-drive side is used to finish out the desired OLD spec. =8-)
So if I pickup a complete "Shimano 2013 Tiagra 10 Speed Rear Bicycle Hub - FH-4600" off Amazon for $30 with free shipping, then I could pilfer the freehub and retrofit my existing wheel's HF05 hub, followed by the normal respace/redish it routine? I am basing this on the many inputs on this forum and the comment on Sheldon that all Shimano 8/9/10 speeds are interchangable (but is the Sheldon page up to date)?
/K
[h=1][/h]