I did not mean that kind of folding leg. But this one looks good but you gotta keep these greased inside. Cast aluminum can't be for heavy duty use in that possition, in fact they have a warning not to sit on the bike with the stand down.
http://www.albabici.com/ursus/kickst...ckstand-80.htm

http://www.ahearnecycles.com/ursus-center-stand/

Below is the Trek Transporter stand. It mounts 10.5" off the ground and is a little lower than the rear axle.
The legs are narrow enough to fit closer to the crank with out foot strike, but I think a regular bike stand mount is a bit higher. They are 9 to 10" wide.

My stand mount is 12.5" off the ground, and I use a 24" tire but the bottom bracket is level with the rear axle.
A regular bike with 26" tire it would be close to the same, maybe 12"?

So the legs would be above the chain and maynot fit right on regular bike, but looks like it will come close, folding down over the chain.





This stand looks very simmular: http://www.crowcycleco.com/double-le...ust-black.html

This one is much nerrower.