Today I was riding and my computer popped out of the stem mount, falling to the ground. When I picked it up, it had gone into reset mode??? Not a huge deal, just went through the setup again at home. It successfully established an ID, and I rechecked my magnet/sensor positions while I was at it.

But for some reason, when it's mounted on the stem mount, it isn't picking up cadence or speed signal. No lights or other electronics on the bike. So I change the batteries, and still, same exact problem after new setup. It WILL pick up information like normal when I take it out of the mount and hold it closer to the sensors but not where it was previously.

Thanks for any help!