Originally Posted by
FBinNY
It's kind of obvious. Unless there's a stop, and some kind of system for leading the inner wire out aligned with the axis of the tube, and a corresponding method for the inner wire to exit at the other end, the housing must go all the way through.
It's easy enough to know by looking a the exit hole, and if it too is 5-6mm in diameter, that means housing in/housing out.
You are absolutely right, I just tried to run housing from the bottom hole and it came right out where it should.
I was just overthinking it, because so used to external cables. What you said makes perfect sense. Thank you very much.
Then, another question, should I lube the housing as I run it through, and what lubricant to use?