Originally Posted by
rpenmanparker
Is the RD installed properly? Can it be rotated counter-clockwise so the screw lines up with the tab if you loosen the attachment bolt?
I'll have to check that at home tonight. It did seem when I fiddled with it this morning that I could move the RD around but when I tried to tighten the screw it seemed to push the screw out of proper angle alignment. Could it be the RD is too loose in the hanger?
Originally Posted by
Retro Grouch
Sometimes running the screw in the opposite direction works better.
I see that works well for many folks, but I was kind of trying to avoid removing the RD if possible...I didn't want to muck about too much with the adjustments since - aside from issues with the largest 27t cog - it's been shifting pretty well. If this recent development means I need to mess with the hanger bolt anyway, maybe I should try reversing it (for better chance of the screw making proper contact against the drop out?)?