Okay, so I bought the Park Tool and another generic brand tool, both which are supposed to do the same job. I had to grind down the generic one a little bit to make it fit and it latches, but still starts to round off the top of the nut because I can't put enough pressure on it I guess, while turning the Allen key.

The Park tool doesn't even fit into the slot because the middle stub on one end is too long and it hits the inside of the bolt. I don't to grind this one down too cause it's nicer.

So as you guys can see, I have the right tools for the job...but they're still not coming off. It's a brand new SRAM S300 1.1 Crankset, never installed on the bike by the way. I just got it. And I'm pretty sure the factory put Loctite on them or some form of glue substance...I can't get any of them off.

Now I'm thinking I have to drill them...any other ideas?