Thread: BB30 to GXP shim problem
View Single Post
Old 06-23-15 | 11:00 AM
  #19  
rpenmanparker's Avatar
rpenmanparker
Senior Member
15 Anniversary
 
Joined: Dec 2009
Posts: 28,682
Likes: 63
From: Houston, TX

Bikes: 1990 Romic Reynolds 531 custom build, Merlin Works CR Ti custom build, super light Workswell 066 custom build

Originally Posted by dalava
I found this to be helpful when I was doing mine (to HollowTech II): Park Tool Co. » ParkTool Blog » BB30 Bearing System Service

I assume that the outer seals of the BB have been removed before the adapters were installed right? The spacers should go on top of the adaptors to adjust width.
I wouldn't think the outer seals would be removed. The shims are like any other spacer, only thicker.
rpenmanparker is offline  
Reply
0