Thread: 3D Printed Accessories / Mounts
View Single Post
Old 09-23-15 | 08:38 PM
  #144  
dwmckee's Avatar
dwmckee
Senior Member
 
Joined: Jun 2008
Posts: 2,468
Likes: 340
From: Pittsburgh, PA

Bikes: Co-Motion Cappuccino Tandem,'88 Bob Jackson Touring, Co-Motion Cascadia Touring, Open U.P., Ritchie Titanium Breakaway, Frances Cycles SmallHaul cargo bike. Those are the permanent ones; others wander in and out of the stable occasionally as well.

Is 3D printing technology to a point where you could design and pritg a good shaped beam reflector for an LED headlight?
dwmckee is offline  
Reply
0