Originally Posted by
69chevy
The top tube length will fit him just fine. The measurements on the "eddy fit" give him 2cm of "wiggle room" on seat height, almost half a mm on setback and over half a mm on seat to bar reach. Then there is over half a mm on stem length.
OP, when you get this bike, fitting will be simple. Set the seat height and setback. Once those are locked in where the calculator puts you, measure the "saddle/handlebar" position. I'm guessing a 100mm stem will be what you need to get the reach it recommends.
There's no gurantee that a calculator works for everyone but if we use if literally the top tube length is a problem. The Eddy fit has a top tube almost 2 cm shorter than the Bianchi. Forgetting about saddle position, the calculator recommends a stem length of 10.5 to 11.1. There's a good chance the OP will need a shorter stem that's outside this range.
That's really not a lot but its something to consider.