I bought a Jamis Exile III off ebay. I was concerned about the seller rebuilding the bike, but made offer and it was accepted.
Bike was in overall great condition except the Shimano X5 2x10 crank was stiff.
Upon tearing it down I noticed that the bearings I.D.s are very shightly larger then the crank---.010/.015?
The bearing next to sprocket has a plastic shim that looks factory and creates a snug fit, but the outer bearing has "play"
When I tighten it all up there is a slight amount of play but crank spins free.
To remove crank arm, you remove a Hollow plug and then remove the mounting screw and slid arm off a 10 tooth spline.
I have done extensive searches but can't find this exact setup.
Anyone familial with this crank?