Originally Posted by
JohnDThompson
Keep in mind that an 8mm measured difference using the "string method" actually means your stays are only 4mm out of alignment, so don't get too carried away when you cold-set it.
But I need to move the right stay 8mm to the left, no? If I move it in 4mm, I'd need to move the left stay 4mm to the left (out) as well. But as I mentioned the rear dropout width is about 8mm too large, so I should just push the right stay 8mm left? (That's assuming I want to keep the old hub with a 110mm OLD). Just trying to make sure I got this right before I attempt it.