Originally Posted by
Andrew R Stewart
Are the casings fully seated and end capped correctly. If the casing isn't tightly up against the hard stop (frame stop or lever seat) it can move during the shifting. And of course there's the cable anchoring that's routed on the wrong side of the bolt or tab. Andy
They
should be. I cut the casing with dedicated cutters, so they are pretty clean and perpendicular. I also put the matching ferrules from Jagwire, which I must say do not fit as tight as say the Shimano sealed. I also tried to crimp them with the same cutter, but they would not deform, which does nor really surprise me since we are talking about plastic. Chances are they either stay as they are or break.
The way the cable is anchored
should also be ok, as I checked the instructions right before doing it to be sure.
Still, the first time I take the bike back on the workstand I will make sure to check for everything all of you suggested.