The manual for that bottom bracket and crank is at
http://si.shimano.com/php/download.p...0E-001-ENG.pdf
The adapters (cups) get tightened to 35 to 50nm or 305-435 in/lbs.
The little cap gets tightened to less than 2nm.
Originally Posted by
HillRider
BTW, since this is a triple HTII crank, there should be a rubber two-part spacer that must be installed on the
non-drive side between the nds crank arm and the bb cup. Be sure you have it. Again, the Shimano manual will give all the needed details. Here is a source for it too:
Shimano Hollowtech II 3mm Triple Crankarm Spacer | eBay
The instructions state this explicitly in step 4. @
HillRider gives very good advice here and throughout this thread.
Don't forget the stopper plate either.
-Tim-