Thanks all for chipping in.
Originally Posted by
jiangshi
Remove the nut(it's a nut) and the washer under it. It is 14mm. Use a standard crank puller. Make sure you thread it in all they way. You likely will need a new bottom bracket that is the correct length for the new crank. You're gonna have chainline issues otherwise, especially with a single speed conversion.
What's the best way to decide on the bottom bracket? Install the rear cog, then measure out the bottom bracket shell to decide? The single speed freewheel I ordered and crank puller tools should arrive Friday, after which I should have a bit more clarity on next steps. Looking online at older posts sounds like best bet is to take to the LBS so I can make sure I buy once