Made pay dirt today was like a dog with a bone could not leave it alone, I was getting nowhere with the saw new wood blade did cut a lot better but you did not know what you where cutting, tube was 10 inches in and I was scared
of cutting into the frame but that would not be a total disaster as I could braize the hole or slot I have plumbers soldering torch would probably not get hot enough for braizing would need oxygen so that's out not to mention the ruined paint job.

Destroying a $45 bike would be no big deal I have done worse, could still sell other parts, but I would look like a total idiot to all the people here reading my posts.

Decided to use drill it was all done in 3 mins just went naturally into tube and reamed it all out as I expected only better.
I should rent it out to bike shops I bet they don't have one, it's the only way to go.
the only problem now it there is still 4 inches still in lower down and drill has no more reach I will try and get an extension I have one but it's for a 1/4 inch drill. I have 6 inches clear so I could leave it but it has to be done right.
Next job remove BB to clean.
the minor marks on the top are from saw if I had used drill they would not be there.
I can order my new decals now there either blue or black, blue would look good, I will wait awhile once you press buy on eBay your locked in.
once saw something better and much cheaper but I had just pressed buy for another item

Bianchi Decals Stickers Bicycle Vinyl Graphics Autocollant Aufkleber Adesivi #2 | eBay


After that, I cleaned rear wheel much more satisfying I could see an end result
I was going to change cassette since they are cheap but this one is like new bike has hardly been ridden as all wearable parts are like that even chain is good




I can explain it to you but I can't make you understand