View Single Post
Old 11-21-17, 10:42 AM
  #9  
Sy Reene
Advocatus Diaboli
 
Sy Reene's Avatar
 
Join Date: Feb 2015
Location: Wherever I am
Posts: 7,014

Bikes: Merlin Cyrene, Nashbar steel CX

Mentioned: 11 Post(s)
Tagged: 1 Thread(s)
Quoted: 3699 Post(s)
Liked 833 Times in 557 Posts
Originally Posted by taz777 View Post
The frame and seatpost is metal, not carbon. The existing bolt clamp has 5Nm written on it. I'm assuming that QR seatposts would be awfully hard to close if too much pressure is being applied to the seat tube/seatpost.

I'm actually more worried about the seatpost slipping!
To help reduce likelihood of slipping, consider using some assembly paste (eg. Park SAC-1).. though if you're removing and substituting the post a lot, this is obviously a pain, and could lead to obvious scratching of the post if one's not careful (though hopefully below the visible area of the post).
Sy Reene is offline