Thread: Hubs and cones
View Single Post
Old 08-23-18 | 06:03 AM
  #3  
seedsbelize's Avatar
seedsbelize
Senior Member
10 Anniversary
 
Joined: Nov 2010
Posts: 15,315
Likes: 903
From: Tixkokob, Yucatán, México

Bikes: 79 Trek 930, 80 Trek 414, 84 Schwinn Letour Luxe (coupled), 92 Schwinn Paramount PDG 5

Originally Posted by Andrew R Stewart
The 3D surface curves that make a cup and cone system are based on bearing contact angle and overall rolling diameter. Then there's the cone's OD matching the hub's dust caps ID. Andy
I get the OD part, but don't understand the profile. Does it actually change with contact angle, or will the same profile provide differing contact angles?
seedsbelize is offline  
Reply
0