The sleeve for the Cervelo fork comes with a star nut in it, and the sleeve is to be epoxied in place
after the steerer is cut to length. It should also have a star nut in it, so if it doesn't... where did it go? You can only run ~40mm spacers below the stem, if I recall the fork manual correctly. This is the part I don't understand:
Originally Posted by
spectastic
I was careful to not make the stem too high from the top of the steerer, and still have enough room to accommodate the top cap. but when I tighten it, I noticed that the top bolt was compressing more than the bottom nut.