Originally Posted by
Doug Fattic
An easy way to check is by putting it on the post on your alignment table and use a machinist square to see if the vertical part touches the end of both slots equally. Bend as necessary
.
Thanks Doug. I didn't get to spend much time on it this evening, but I did put up a square up to the drops outs and there is about a 1-1.5mm difference. When trying to bend them, I notice that the BB is twisting. I assume that the twisting is only a result of the forces that I'm putting on it and shouldn't be an issue. I still need to face the BB though and I'll check it out again.