Originally Posted by
Sy Reene
Whose spec? In order:
1. The saddle maker's or the seatpost maker?
2. The stem maker's or the handlebar's maker
3. The derailleur maker's or the the frame maker's?
And, do you find wet (greased) vs dry guidance for all of this?
Thanks for responding.
1. Most likely seatpost
2. I used the stem spec because the handlebar was aluminium
3. I meant the derailleur and break wire tightening bolts
I make sure the threads are clean, and don't use any grease on torqued bolts.
If I remember there is a special compound used in industry where you are suppose to applied to threads before torquing.