Firedog,
I read your posts carefully about power tool batteries you used with your Eplus.
you obviously change my schematics of conversion to non-Eplus battery.
You obviously forgot about electronics BMS inside power tool packs,
no wonder your Eplus acted like you described.
and to blame EPLUS???
my conversion schematics is simple as hell , you connect 10 or 11 cells in series to Eplus power board NOTHING MORE,
but
you connected power tool packs electronics to my conversion scheme and you expect no problems?
You must first understand what happens when these power tool BMS interfere with upper Eplus BMS board /called processing board or control board/
especially if you tap into two cells to connect to processing upper board
you add such complexity to all conversion schematics.
again
my conversion schematics shows only 11, 12 cells in series connected terminals of Eplus power board.
again
BMS electronics inside power tool pack monitors every cell during charging and discharging, they cannot disconnect wires going to individual cells EXCEPT openning pack and cutting wires. If you want to use power tool pack you must disconnect electronics inside.
outside pins/connectors does not allow to isolate cells from electronics
Last edited by powell; 02-07-21 at 08:01 AM.