Below is a FD1055 that I had planned on using with a build. However when placed on the DT, I noted the "irregularities" of the FD on the frame. Thoughts on if it is correctable with a "little coercion" with a pair of pliers? Also, I'm trying to figure out how the FD got in this condition, aka with way did it take a blow so that I can force it back into its correction orientation, if possible. I definitely don't want to tighten the clamp on the DT for fear of crimping the Prestige tubing with the lower edge of the clamp out of alignment.

Thanks in advance!