Thread: Vertically truing a new wheel
View Single Post
Old 04-25-21 | 08:52 PM
  #5  
zandoval's Avatar
zandoval
Senior Member
Titanium Club Membership
15 Anniversary
 
Joined: May 2010
Posts: 5,579
Likes: 2,450
From: Bastrop Texas

Bikes: Univega, Peu P6, Peu PR-10, Ted Williams, Peu UO-8, Peu UO-18 Mixte, Peu Dolomites

Originally Posted by cxwrench
...I have one of those Problem Solvers things that goes into an electric drill. The end looks like a flat screwdriver w/ a hole in the center that fits a piece of 2.0mm spoke. You can adjust how far it sticks out.
OK Stud... Ya got me. Not that I rebuild wheels very often but it sure looks like I need one of these. How about a pic or a link?
__________________
No matter where you're at... There you are... Δf:=f(1/2)-f(-1/2)
zandoval is offline  
Reply
0