View Single Post
Old 09-13-21, 02:42 AM
  #9  
Tanielsarafyan
Newbie
 
Join Date: Sep 2021
Location: Leeds
Posts: 2

Bikes: Burley duet s&s.

Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Likes: 0
Liked 0 Times in 0 Posts
Originally Posted by Rick View Post
I have a Burley Bongo. I have replaced the bearings and spindle up front with Phil Wood parts and kept the rear one in good running order by removing the outer seals and working grease into them. I will be striping it down and sending it out for minor frame repair and some hydraulic cable guides. I use hydraulic rim brakes on it.
I haven't extracted the spindle or bearings from the eccentric just removed the whole unit, I can't see any clips holding the bearings in, is it entirely push fit?

How have you gone about getting the spindles and bearings back into place, did you use any locking compound?

Thanks

Tan
Tanielsarafyan is offline