View Single Post
Old 11-26-21, 09:08 PM
  #8  
steelbikeguy
Senior Member
 
steelbikeguy's Avatar
 
Join Date: Feb 2008
Location: Peoria, IL
Posts: 3,168
Mentioned: 72 Post(s)
Tagged: 0 Thread(s)
Quoted: 1205 Post(s)
Liked 1,437 Times in 731 Posts
Originally Posted by grant40 View Post
I do remember seeing a picture of this bike in better condition on old10speedgallery a while back.

I did find this on Sheldon Brown's website though.



There was also a square taper version as well.
I have/had a flyer from Bullseye circa 1990's that still listed their severely elliptical chainring, along with their other interesting products.



This was about the time that I had bought one of their roller bearing bottom brackets. Very rugged, but used an oil bath instead of the typical grease. There was always a bit of oil getting past the axle seals, so oil drips were inevitable. For me, this was the kiss of death, and I installed a regular cup and cone bottom bracket again.

Steve in Peoria
steelbikeguy is offline  
Likes For steelbikeguy: