Originally Posted by
HillRider
Yes, a master link is included in the chain length. Without a master link the chain would be joined by reusing a standard pin (older 5/6-speed) or a special joining pin (7+ speed). The "+1" accounts for the extra chain length required to allow the chain to clear the cog or chainring teeth height while shifting.
aaah ok then my chain is a bit long. I wasn't sure if the master link was part of the calculation so i didn't cut the chain and added the master link. So, I will attached one side of the master link, and re-measure the chain from end to end.
thankx for the heads up on this.
