Originally Posted by
HillRider
What happens with the odd-ball caliper if you just try to center it normally by loosening the bolts, squeezing the brake lever and re-torquing the bolts? Does it shift as the bolts are tightened?
I'll try to see that, but when the lever is squeezed, both pads are tight against the rotor, so I don't think I could see if they shifted when the bolts are tightened. But I'll look closely next time
Originally Posted by
Barry2
I’ve one where the keep squeezed while tighten, results in it rubbing a pad.
I slip a piece of a business card in the side that rubs, then keep squeezed while tighten.
Barry
I have tried that, but it didn't work. I'll try again, and also look more closely as to what is actually happening when I try to go through the routine as mentioned above.