Originally Posted by
retswerb
I'd be very hesitant to use those 3d printed ones. Seller isn't being very clear about the material used and the printing direction is wrong - set up for printing convenience, not for part strength.
I agree, they don't look as if they could hold up to either a heavy load or rough road conditions.
Originally Posted by
Robvolz
...Thanks for the tip Bob, Aluminum briefcase is out. But, maybe the old bar case!!
Maybe mount the aluminum briefcase horizontal on a front or back rack and it would be a secure Boot or Bonnet (aka British style).
Originally Posted by
bikamper
Not sure if this is what you are looking for but below is a seatbag I made from an old boy scout Yucca pack....
There has been decorating over the years.
Well done! Is there a camp stove under the kettle that's ready to fire-up?
I might purchase the
Vincinta adapters for my next project. All leather, or leather and canvas panniers.