Originally Posted by
cobba
What's in that image mightn't look as extreme in real life it.
So when you look in where the green arrow is pointing, there's no part of the pad overhang of the rotor?
The bottom of your flipped rear adapter is similar position to a front 160mm adapter, the top of your setup is completely different, there must be some of the pads overhanging the rotor.
I've stared down inside the caliper until I near gone blind, both pads are level with the top of the rotor. It is difficult to get a photo, but if you look at the bottom of the pads in the photo you reposted, you can see the bottom of those pads are level, since the pads are the same size, then the top of the pads are level with the top of the rotor, and I can confirm this by sighting inside the caliper and I see the pads are level with the top of the rotor.