Originally Posted by
smd4
Again, this is the way I would do it. Toss the cones. I "Centering the press" isn't too difficult, and they press straight down, so I wouldn't worry too much about the cups going in "cock-eyed."
i have a Park HHP-3 press.. it works by pressing on the rims of the cups.. and it works wonderfully after i fitted a couple straight 3/4" ID PVC couplers onto it.... along with the supplied spacer, i can mix/match to achieve the needed centering, thereby maintaining near vertical alignment to the cups and frame.
it also doubles as a BB cup press.. some careful hand alignment is required.
and i always have a decent 2x4 trim piece and my Mac deadblow around, if needed.
i'm amazed that no one has mentioned using a bearing/race/seal installer of the correct size....
https://www.ebay.com/itm/19393832361...Bk9SR4Ce1s6uYg