I realize now I should have slotted them with the Dremel, but I drilled them out to remove the rotor. Now the studs are still in the hub.
Originally Posted by
choddo
If you use a reverse bit, try drilling a tiny hole in the centre of the bolt to give it some purchase. On a steel bolt, this is easier said than done.
+1 on the pilot hole to give the LH bit a bite. If I've reading this right, you have drilled the head off the bolt so there should be an indention from that process to drill into.
__________________
"It is the unknown around the corner that turns my wheels." -- Heinz Stücke